Culligan Aquasential Select Plus & Select Series Iron-OX5 & Sulfur-OX3 Water Filters 01040683
Service
36
Eductor Piston / Eductor Sleeve Assembly
Follow the instructions for replacing the drive motor assembly through step 7, then proceed as follows:
1.
With the drive motor set aside, firmly pull the eductor piston & sleeve assembly from the valve body.
2.
Lightly lubricate the o-rings of the replacement piston & sleeve assembly with silicone grease.
3.
Reverse the procedure for reassembly.
NOTE!
Use only silicone grease; petroleum-based lubricants will cause the degradation of the rubber components.
The eductor piston and sleeve assembly is unique to the Iron-OX5 and Sulfur-OX3 system. Refer to the
parts list to ensure the proper parts are used.
Eductor Assembly
Refer to the following instructions for replacement of the eductor.
1.
Remove the three screws and the eductor plate.
2.
Remove the eductor screen by lifting it from the eductor body.
3.
Remove the eductor body by grasping one of the projections with the pliers and gently pulling upward.
4.
Reverse the procedure to reassemble. Be certain that the replacement eductor body contains the correct
eductor nozzle.
Table 6. Eductor Selection
Model
Nozzle Color
Nozzle with O-Ring P/N
10” Aquasential Select Plus Iron-OX5 and Sulfur-OX3
Green
01034602
Backwash Flow Control
Refer to the following instructions for replacement of the backwash flow control:
1.
Remove the drain elbow retaining clip from the valve body.
2.
Pull the drain elbow from the valve body.
3.
Remove the flow control from the valve body and replace with a new flow restrictor.
NOTE!
The number on the backwash flow control should face into the valve body.
4.
Reverse the procedure to reassemble. Be certain that the replacement is the correctly sized flow restrictor.
Table 7. Backwash Flow Restrictor
Model
Color & Number
P/N
10” Aquasential Select Plus Iron-OX5 and Sulfur-OX3
Black - 5.5 GPM
P0401031 - 10 ea.
