156
CHAPTER 3
CLI CONFIGURATION
Parameters:
pcp <pcp: 0-7>: Specify a PCP (Priority Code Point) value.
dei <dei: 0-1>: Specify a DEI value (0 or 1).
cos <cos: 0-7>: Specify a QoS class value.
dpl <dpl:0-1>: Specify a DPL value (0 or 1).
Negation
: (config-if)# no qos map tag-cos pcp <pcp> dei <dei>
Show:
# show qos
# show qos [ { interface [ ( <port_type> [ <port> ] ) ] } | wred | { maps [ dscp-cos ] [ dscp-ingress-translation ]
[ dscp-classify ] [ cos-dscp ] [ dscp-egress-translation ] } | storm | { qce [ <qce> ] } ]
3.9.37.17 (config-if)# qos pcp
Syntax:
(config-if)# qos pcp <pcp>
Explanation:
Configure PCP value for specific interface.
Parameters:
pcp <pcp: 0-7>: Specify a PCP (Priority Code Point) value.
Negation
: (config-if)# no qos pcp
Show:
# show qos
# show qos [ { interface [ ( <port_type> [ <port> ] ) ] } | wred | { maps [ dscp-cos ] [ dscp-ingress-translation ]
[ dscp-classify ] [ cos-dscp ] [ dscp-egress-translation ] } | storm | { qce [ <qce> ] } ]
3.9.37.18 (config-if)# qos policer
Syntax:
(config-if)# qos policer <rate> [ fps ] [ flowcontrol ]
Explanation:
Configure PCP value for specific interface.
Parameters:
<rate>: Indicate the rate for the policer. By default, 500kbps is used. The allowed range for kbps and fps is 100 to
1000000. The allowed range for Mbps and kfps is 1 to 3300Mbps.
[ fps ]: Rate is fps. By default, kbps is used.
[ flowcontrol ]: Enable Flow Control. If flow control is enabled and the port is in flow control mode, then pause
frames are sent instead of discarding frames
Negation
: (config-if)# no qos policer
Show:
# show qos
# show qos [ { interface [ ( <port_type> [ <port> ] ) ] } | wred | { maps [ dscp-cos ] [ dscp-ingress-translation ]
[ dscp-classify ] [ cos-dscp ] [ dscp-egress-translation ] } | storm | { qce [ <qce> ] } ]
Summary of Contents for IFS-1604GSM Series
Page 385: ......
