120
CHAPTER 3
CLI CONFIGURATION
3.9.29.7 (config)# mep <inst> dm
Syntax:
(config)# mep <inst> dm <prio> [ multi | { uni mep-id <mepid> } ] [ single | dual ] [ rdtrp | flow ] interval
<interval> last-n <lastn>
Explanation:
To configure Delay Measurement of a MEP.
Parameters:
<inst>: Specify an instance ID number.
dm <prio: 0-7>: Configure Delay Measurement (DM) priority value. Priority in case of tagged OAM. In the EVC
domain this is the COS-ID.
[ multi | { uni mep-id <mepid> } ]: Specify multicast or unicast MEP ID.
[ single | dual ]: One-Way or Two-Way Delay Measurement implemented on 1DM or DMM/DMR, respectively.
[ rdtrp | flow ]: Specify one value.
rdtrp:
The frame delay calculated by the transmitting and receiving timestamps of initiators. Frame Delay =
RxTimeb-TxTimeStampf.
Flow:
The frame delay calculated by the transmitting and receiving timestamps of initiators and remotes.
Frame Delay = (RxTimeb-TxTimeStampf)-(TxTimeStampb-RxTimeStampf).
interval <interval>: Interval between PDU transmission in 10ms. Min value is 10.
last-n <lastn>: The last N dalays used for average last N calculation. Min value is 10.
Negation:
(config)# no mep <inst> dm
Show:
# show mep [ <inst> ] [ peer | cc | lm | dm | lt | lb | tst | aps | client | ais | lck ] [ detail ]
Clear:
# clear mep <inst> { lm | dm |tst }
3.9.29.8 (config)# mep <inst> dm ns
Syntax:
(config)# mep <inst> dm ns
Explanation:
Configure Delay Measurement (nanosecond) of a MEP.
Parameters:
<inst>: Specify an instance ID number.
Negation:
(config)# no mep <inst> dm ns
Show:
# show mep [ <inst> ] [ peer | cc | lm | dm | lt | lb | tst | aps | client | ais | lck ] [ detail ]
Clear:
# clear mep <inst> { lm | dm |tst }
Summary of Contents for IFS-1604GSM Series
Page 385: ......
