Chapter 4. Web Configuration & Operation
217
CHAPTER 4
WEB OPERATION & CONFIGURATION
100Mbps HDX:
Forces the port to 100Mbps half duplex mode.
100Mbps FDX:
Forces the port to 100Mbps full duplex mode.
1Gbps FDX
: Forces the port to 1Gbps full duplex (IGS-812/1604 Series only).
Possible fiber port settings are:
Disabled:
Disables the switch port operation.
Auto:
Port auto negotiating speed with the link partner, selecting the highest speed that is compatible with the
link partner.
100Mbps FDX:
Forces the fiber port to 100Mbps full duplex mode.
1Gbps FDX
: Forces the fiber port to 1Gbps full duplex mode.
Flow Control:
The Current Rx column indicates whether pause frames on the port are obeyed, and the Current Tx
column indicates whether pause frames on the port are transmitted. The Rx and Tx settings are determined by the
result of the last Auto-Negotiation. Check the configured column to use flow control. This setting is also related to the
setting for Configured Link Speed.
Maximum Frame Size:
Enter the maximum frame size allowed for the switch port, including FCS. This switch supports
up to 9600 byte packets.
Excessive Collision Mode:
This setting configures the port transmit collision behavior to either "Discard" (Discard
frame after 16 collisions - default) or to "Restart" (Restart backoff algorithm after 16 collisions).
4.4.2 Ports State
Display an overview graphic of the switch.
This is the same graphic overview shown when first logging into the switch for management. "Green" colored ports
indicate a 100M linked state, while "Amber" colored ports indicate a 1G linked state. "Grey" ports have no link. The
link status display can be updated by clicking the "Refresh" button. When "Auto-refresh" is checked, the display will be
updated every 3 seconds.
Summary of Contents for IFS-1604GSM Series
Page 385: ......
