CSI Wireless Seres, Reference Manual

Page: 49 / 134

Seres Reference Manual
29
Figure 2-3 Pole Mount
Caution - Install the antenna only hand-tight. Damage resulting
from over-tightening the antenna is not covered by warranty.
2.6.4 Powering the Seres
The first step to powering the Seres is to terminate the power leads of the
extension cable. There are a variety of power connectors and terminals on
the market from which to choose, depending on your specific
requirements. We suggest that a weather-tight connection and connector
be used if the connection will be located outside or if it will be part of a
portable system.
Caution - do not apply a voltage higher than 32 VDC as this will
damage the receiver and void the warranty
To turn the Seres on:
•
Connect the red wire of the cable’s power input to DC positive (+).
•
Connect the black wire of the cable’s power input to DC negative (-).