Seres Reference Manual
68
The Seres will reply with the following response:
$>
5.5
SBAS Commands
This section details the NMEA messages accepted by the internal SBAS
engine of the Seres system.
The following table provides a brief description of the commands
supported by the SBAS demodulator for its control and operation.
Table 5-4 SBAS Commands
Message
Description
$JWAASPRN
This message is used to reconfigure the WAAS PRN numbers for
use with other Space Based Augmentation Systems (SBAS)
$JGEO
This command is used to poll the WAAS demodulator for
information relating to your current location and WAAS satellites
$JRD1
This command is used to poll the Seres for SBAS diagnostic
information
$JASC,RTCM
This feature allows you to configure the Seres to output RTCM
data from the WAAS demodulator
The following subsections provide detailed information relating to the use
of each command.
Note - Please ensure that you save any changes that you wish to
survive beyond the current power-up by using the $JSAVE
command and wait for the ‘
$> Save Complete’
response.
Summary of Contents for Seres
