CSI Wireless Seres, Reference Manual

Page: 72 / 134

Seres Reference Manual
52
Where feature status variable, ‘r’, may be one of the following values:
r Description
0 ON
1 OFF
The Seres will reply with the following response:
$>
5.3.3 $JASC,VIRTUAL
When using an external correction source, this command is used to ‘daisy
chain’ RTCM data from being input from one port and output through the
other. For example, if RTCM is input on Port B, this data will correct the
Seres position and also be output through Port A. The Seres acts as a
pass-through for the RTCM data. Either port may be configured to accept
RTCM data input and this command then allows the opposite port to
output the RTCM data.
To configure the Seres to output RTCM data on the current port from
data input on the other port, issue the following command:
$JASC,VIRTUAL,r<CR><LF>
To configure the Seres to output RTCM data on the other port from
RTCM data input on the current port, issue the following command:
$JASC,VIRTUAL,r,OTHER<CR><LF>
Where the message status variable, ‘r’, may be one of the following:
r Description
0 ON
1 OFF