Crystal Vision
The card edge display
TANDEM-110 User Manual R1.8
57
07/07/2010
Mono operation
If an input card is fitted, the mono function follows the router and any of the four output
channels can be set as the mono sum of its stereo pair. If an output card is fitted, the mono
function precedes the router and input channels 1&2 and input channels 3&4 can be
configured as either a stereo or mono source.
The Mono menu is obtained by setting MENU levers 4 and 5 both ON (DOWN) and all
other levers UP or OFF.
Rotate the ADJ shaft encoder to toggle between mono and not mono modes for the
function chosen with the SEL switch.
The available mono/stereo settings are summarised in the following table:
SEL
No.
Function
Mono
Not mono
ADJ toggle action
0
Side 1, C
Embedder
CH 1, op mono
CH 1, op not mono
Switch C1 output between
mono and not mono
1
Side 1, C
Embedder
CH 2, op mono
CH 2, op not mono
Switch C2 output between
mono and not mono
2
Side 1, C
Embedder
CH 3, op mono
CH 3, op not mono
Switch C3 output between
mono and not mono
3
Side 1, C
Embedder
CH 4, op mono
CH 4, op not mono
Switch C4 output between
mono and not mono
4
Side 2, D
Embedder
CH 1, op mono
CH 1, op mono
Switch D1 output between
mono and not mono
5
Side 2, D
Embedder
CH 2, op mono
CH 2, op mono
Switch D2 output between
mono and not mono
6
Side 2, D
Embedder
CH 3, op mono
CH 3, op mono
Switch D3 output between
mono and not mono
7
Side 2, D
Embedder
CH 4, op mono
CH 4, op mono
Switch D4 output between
mono and not mono
8
Side 1, De-
embedder
A1 + 2 mono
A1 A2
Switch A1 and A2 inputs
between mono and not mono
9
Side 1, De-
embedder
A3+4 mono
A3 A4
Switch A3 and A4 inputs
between mono and not mono
A
Side 2, De-
embedder
B1 + 2 mono
B1 B2
Switch B1 and B2 inputs
between mono and not mono
B
Side 2, De-
embedder
B3+4 mono
B3 B4
Switch B3 and B4 inputs
between mono and not mono
Notes:
Mono/not mono status can only be changed for those functions supported by the option
cards fitted. No Dn pres or No Cn pres will be shown if there is no input card in side 1 or
side 2 respectively, where n is the channel number (nothing to embed).
No A1, A2/A3, A4 or No B1, B2/B3, B4 will be shown if there is no output card on side
1 and side 2 respectively (nothing to de-embed to).
