Crystal Vision TANDEM-100, User Manual

Page: 100 / 104

Crystal Vision
Problem solving
TANDEM-110 User Manual R1.8
99
07/07/2010
Further help
Other Status menus such as the Status Only menus discussed in section 5.1 and the
Ancillary Data Status menu discussed in section 5.7 will also prove to be useful during
fault finding.
It is also useful to listen to any valid audio destination with a pair of headphones using the
audio monitoring facility discussed in section 5.4
If the Auto menu is left as the default for the card edge display, (All MENU levers UP,
SEL position 0), then the first three status menus will be displayed on a priority basis.
This will provide continuous monitoring of SDI signal status, AES and Ref I/P status and
whether any active audio channels fall silent (<50dB FS). This is recommended for
normal operation.
Control cross reference
Piano switch Hex
switch Description Statesman Card-edge
section Front
panel
menu
all up 0 - 5 display status SDI 1/2 Status 5.1 1.1
6 - 9 select audio group SDI 1/2 Status 5.3 1.2.1, 1.2.2
A, B select audio monitor Preset Controls 5.4 1.4
C, D adjust audio delay Audio Delay 5.3 1.2.3
E adjust silence time Misc 5.3 n/a
F GPI enable / disable Preset Controls 5.5 1.3.2.4
2 only down 0 - 15 preset 0-15 save / recall Preset Controls 5.6 1.3.2
3 only down 0 - 1 display mode – always 1 n/a 5.14 1.3.1
2 SDI PLL mode Preset Controls 5.12 1.3.3
3 Resample mode n/a 5.12 1.3.4
4 - F Factory use only n/a 5.14 n/a
4 only down 0 - F configure audio routing Audio Router 5.3 1.2.4
5 only down 0, 1 select error handling level Misc 5.7 n/a
2 - 5 embed / de-embed formats SDI 1/2 Status 5.7 n/a
6, 7 select stereo/dual mono SDI 1/2 Status 5.8 n/a
8, 9 contiguous pack (embed) –
always contig n/a 5.7 n/a
A, B Blank HANC n/a 5.7 n/a
C, D EDH on/off SDI 1/2 Status 5.7 n/a
E, F adjust AES phase Misc 5.9 n/a
5&6 only
down 0-3 Audio gain menus for
embedder router inputs Audio Gain 5.3 1.2.4.2
6 only down 0-9 GPI output error masking Misc 5.10 n/a
B load default settings n/a 5.2 n/a
C diagnostic data Tool Kit n/a n/a
D firmware version number Board Info 5.14 1./Device
E, F display ancillary data
status Tool Kit 5.1, 5.7 n/a
7 only down 0-5 De-embedded signal status SDI 1/2 Status 7.0 1.1.1, 1.1.3
6-8 General status Tool Kit 7.0 1.1
9-C Output signal status SDI 1/2 Status 7.0 1.1.2, 1.1.4