14
Peristaltic Pumps Series IP 100-800
Blown fuses must not be repaired or bridged
and may only be replaced by fuses of the same
type.
Cooling facilities, such as ventilation slots, must
not be made ineffective.
Rotating or moving parts must be reliably
stopped before starting work. It must be
assured that these parts will not start to move
while work is in progress.
Do not touch rotating parts and always keep a
safe distance to avoid clothing or hair being
caught.
Always wear protective clothing suitable for the
job and the related dangers.
Depending on the type of work to be performed
sufficient protection may be provided by e.g.
wearing the following protective clothing:
Protective goggles, ear defenders, working
boots, safety gloves, etc.
Protective clothes should be of tight fit.
If your face could come in contact with
chemicals, metal splinters or dust during work,
you should wear a full face protection with
safety goggles.
Always wear safety boots where there is a risk
of heavy objects tipping over, slipping or coming
loose for any other reason, thereby causing
danger for your feet.
2.7.1 Health and safety information on
electric equipment
Depending on the version, the pumps may be
equipped with electric accessories (controls,
motor drives).
Severe damage to health and property can be
caused by:
•
unauthorized removal of covers
•
unprofessional use of pump
•
inadequate maintenance
Before starting installation work on electrical
equipment this equipment must be reliably de-
energized.
Cover non-insulated live power lines and plug
connections against unintended contact.
Electric components stored and not used for a
longer period of time should be carefully
inspected before use, to ensure that the
insulation is still intact.
Wet electric assemblies or components parts,
which would be perfectly de-energized in dry
condition, may still be live.
Before touching damp or wetted electric
components check by measuring whether parts
that could be touched are still live.
When working on high voltage assemblies after
voltage has been switched off, connect the
supply cable to ground and short components,
e.g. capacitors, via a discharge combination.
Do not attempt to insert any objects through the
openings on pump or attached equipment. This
may cause short circuit and electric shocks with
danger to life.
2.7.2 Health and safety information for work
on pressure lines
Always relieve the pressure before starting
work on pressure lines.
•
Close shut-off valves
•
Vent pressure lines
Be careful when checking for leaks
on pressurized lines. Fluids or air
escaping under pressure can
penetrate clothes and skin.
Be careful when loosening or
changing pressure lines; lines
mixed up by mistake may reverse
the function.
Always relieve the pressure from hydraulic or
pneumatic systems and move mobile parts to a
Caution!
Summary of Contents for ELRO IP 100
Page 4: ...4 ...
