Cradlepoint COR IBR350, Manual

Page: 75 / 148

Figure 98: QoS Traffic Shaping Rule Example
Click
Next
to continue to the next page.
Use ports and/or IP addresses to define the type(s) of traffic attached to this rule. Leaving any field blank will match all values; all fields are optional.
SourcePort(s) and/or DestinationPort(s) : Enter a port number between 1 and 65535. To enter a single port number, input the number into the
left box. To enter a range of ports, fill in both boxes separated by the colon. For example “80:90” would represent all ports between 80 and 90
including 80 and 90 themselves.
SourceIP Address , SourceNetmask , DestinationIP Address , and DestinationNetmask : Specify an IP address or range of IP addresses by
combining an IP address with a netmask for either “source” or “destination” (or both). Source vs. destination is defined by traffic flow. Leave these
blank to include all IP addresses (such as if your rule is defined by a particular port instead).
EXAMPLE:IfyouwanttoassociatethisrulewithyourguestLAN,youcouldinputtheIP addressandnetmaskfortheguestLAN here(leavingthe
lastslot“0”toallowforanyuserattachedtotheguestnetwork):
• SourceIP Address: 192.168.10.0
• SourceNetmask: 255.255.255.0
DSCP (DiffServ) : Differentiated Services Code Point (DSCP) is the successor to TOS (Type of Service). Use this field to select traffic based on the
DSCP header in each IP packet. This field is sometimes set by latency sensitive equipment such as VoIP phones.
This setting is optional. For more information see the Differentiated services Wikipedia page .
DSCP Negate
: When checked this rule will match on any packet that does not match the DSCP field.
Click Finish to save this rule.
Routing
Add a new static route to the IP routing table or edit/remove an existing route.
Static routes are used in networks with more than one layer, such as when there is a network within a network so that packet destinations are
hidden behind an additional router. Adding a static route is a way of telling the router about an additional step that packets will need to take to
reach their destination.
Click Add to create a new static route.
75