Cradlepoint COR IBR350, Manual

Page: 57 / 148

• AccessControl (Admin Access, UPnP Gateway, LAN Isolation)
•
AttachedInterfaces
(Ethernet ports, WiFi, VLAN)
Click Add to configure a new network, or select an existing network and click Edit to view configuration options.
LocalNetworkEditor
Click
Add
or select a network and click
Edit
to open the
LocalNetworkEditor
to make configure a LAN. The
LocalNetworkEditor
contains the
following tabs: General Settings, IPv4 Settings, IPv6 Settings, Interfaces, Access Control, IPv4 DHCP, IPv6 Addressing, Multicast Proxy, Schedule,
VRRP, STP, and Wired 802.1X.
Figure 75: Local IP Network Editor
GeneralSettings Enabled
: Click to manually disable a network. Also, some settings could cause a network to be automatically disabled: click
here to re-enable the network.
Name
: This primarily helps to identify this network during other administration tasks.
Hostname : [Default: cp (for Cradlepoint)] The hostname is the DNS name associated with the router’s local area network IP address.
NOTE:Youcanaccesstherouter’sadministrationpagesbytypingthehostnameintoyourbrowser, soifyouchange“cp”toanotherhostname, you
canaccesstheadministrationpagesthroughthenewhostname.
IPv4Settings IP Address : This is the address used by the router for local area network communication. Changes to this parameter may require
a restart to computers on this network.
Each network must have a distinct IP address. Most users will want an address from one of the following private IP ranges:
• 10.0.0.1 - 10.255.255.255
• 172.16.0.1 - 172.31.255.255
• 192.168.0.1 - 192.168.255.255
57