![background image](http://html.mh-extra.com/html/cpi/t02ko/t02ko_installation-and-operation-manual_2674996038.webp)
KA BAND OUTDOOR TWT AMPLIFIER
3-6
When an amplifier is found, the type and address will show briefly before scanning resumes.
Scanning stops at address 111 or restarts at 48 if no amplifiers are found.
FOUND 400W AT 55
After the address scanning is complete, the display will show the Amplifier status screen or the
System screen if a switch system was found. The number on the left-hand side of the display
shows which amplifier is currently being monitored.
System Screen:
A1: XMIT 53.3 dBm ON-line A2: FLT 00.0 dBm OFF-line
A3: XMIT 52.1 dBm ON-line MANUAL
Amplifier Screen:
1
RMT TRANSMIT
47.8 dBm MANUAL
REFL RF:18 W
HELIX I:5 mA HELIX V: 8.61 kV
The RCU will continue to monitor the fault status of all units found but can only display the
settings and meter readings for one unit at a time. To select a different unit, press the
AMP
key or
press the
left / right
arrows. The address of the newly selected unit is shown at the far left side of
the display. Pressing the
ENTER
key takes you to the Main menu for that unit.
If a fault occurs in a unit not currently selected, the Panel will automatically switch to the faulted
unit and display its fault status. Other units can be selected as described above, but the alarm will
sound as long as any unit has a fault.
If another fault occurs in a unit other than the first faulted one, the Panel will switch to the second
faulted unit. The Remote Panel will always switch if there is a communication fault.
The Menu selections for the amplifier are shown when the
MENU
key is pressed. Press the
left /
right
arrows or repeat pressing the
MENU
key to show the menu selections for other amplifiers.
Use the
up / down
arrows to make a selection then press
ENTER
to go to the selected screen.
1
□
SETTINGS
□
METERS
□
METER LOG
□
TIME
□
VERSION
To configure the RCU, change the amplifier number by pressing the
MENU
or
left / right
arrows until a
P
is shown on left-hand side of the display. The Menu now shows the
configuration selections for the RCU. Use the
up / down
keys to make a selection then press
ENTER
to go to the selected screen.
INSTALLATION AND OPERATION MANUAL