KA BAND OUTDOOR TWT AMPLIFIER
1-4
Chapter 1, “
Introduction
”, contains a brief overview of the amplifier and this manual.
Chapter 2, “
Unpacking and installation
”, contains procedures for unpacking and installing the Ka-
Band TWTA.
Chapter 3, “
Initial Power ON and Checkout
”, describes the controls and indicators on the front panel
of the amplifier, the CPI Remote Control Unit controls and indicators, and the procedures to use
for initial checkout after the amplifier has been installed.
Chapter 4, “
Interfaces
”, describes:
•
The ODU Amplifier external interfaces and external connector pinouts.
•
The commands used to setup the serial interface hardware characteristics.
Chapter 5, “
Operation
,” describes the procedures for normal start-up and shutdown, and describes
the operational modes of the amplifier.
Chapter 6, “
Maintenance
,” describes the procedures for scheduled maintenance and the procedures
for return of equipment to CPI.
Chapter 7, “
Drawings
,” contains relevant engineering drawings and specifications.
The Appendices contain additional topics such as “Service and Warranty.” information and
optional features.
1.4 Conventions
The following symbols and conventions are used in this manual. These symbols differ slightly
from International symbols to emphasize the specific nature of the hazards.
1.4.1 Notes
and
Cautions
NOTE: Notes provide additional commentary or technical information.
CAUTION!
Cautions identify conditions, operations, or procedures
that could potentially damage the equipment.
INSTALLATION AND OPERATION MANUAL