Coyote Point Systems Equalizer, Installation And Administration Manual

Page: 107 / 144

Equalizer Installation and Administration Guide 97
Equalizer administration page takes a long time to display
Possible cause: DNS server configured on Equalizer is not responding.
✔ Check that Equalizer has IP connectivity to the name server configured using the
serial configuration utility.
✔ If you want to disable DNS lookups on Equalizer, specify a name server IP address
of 0.0.0.0 in Equalizer's serial configuration utility.
Equalizer doesn’t respond to pings to the admin address
Possible cause: Equalizer is not powered on.
✔ Check that power switch is on and the front panel LED is lit. Connect the keyboard
and monitor, cycle the power, and watch the startup diagnostic messages.
Possible cause: Equalizer isn't connected to your network.
✔ Check the network wiring.
Possible cause: Administration address not configured on interface FXP0.
✔ Use the Equalizer Configuration Utility to set the IP address and netmask for
interface FXP0. Be sure to commit your changes.
Browser hangs when trying to connect via FTP to an FTP cluster
Possible cause: The FTP server returns its private IP address in response to a “PASV”
command. (This behavior is particularly likely to cause problems if you’re using reserved
internal addresses for the servers.)
✔ Enable PASV mode FTP translation on the Advanced options page of the Equalizer
Administration utility. (For more information, see “Enabling Passive FTP
Connections” on page 53.)