Cooper Menvier 9752, Installation And Programming Manual

Page: 58 / 96

4. Programming
52 496792
This Command determines what the system will do if a user strays from an
entry route during entry. (This Command is available to provide compliance
with EN 50131-1.)
Use option 0 to make the system give an alarm immediately if the user strays
from an entry route during entry.
If you use option 1 and the user strays from an entry route zone during entry
then the system waits 30 seconds before raising a full alarm. The system
also gives an internal alarm during the 30 second wait.
If the user enters an access code before the end of the 30 seconds internal
alarm then the user can reset the system.
Silent or Audible PA (Command 30)
This Command selects how the system responds when a PA zone operates.
Option 0 (Audible PA): The system operates the sounders and, if a commu-
nicator is fitted, sends a PA message to the ARC.The keypad
displays the PA zone when a user disarms the system.
Option 1 (Silent PA): The sounders stay silent. If a communicator is fitted
the system sends a PA message to the ARC.The keypad displays
the PA zone when a user disarms the system.
Zone Tamper Reset (Command 31)
Use this Command to ensure that the system complies with Scandinavian
requirements for resetting zone tamper alarms while the system is unset.
Use option 0 to allow user reset after a zone tamper.
Use option 1 to enforce engineer reset. The user can silence the alarm, but
the engineer must reset the system by entering the engineering access code,
or by using anti-code or remote reset.
System Reset (Command 33)
If you wish to make the system engineer reset, then use option 1. For user
reset use option 0.
Certain types of event will always need an Engineer reset, no matter what
option you choose for Command 33. These events are:
Auxilliary 12V supply fuse blown.
Keypad missing or failed.
Remote expander missing or failed.
A low battery at the control unit.
Note: To comply with DD243: 2002 use Engineer Reset (option 1). In addition, you
can use various other forms of reset, such as RedCare (see Command 23) or
Anti-code (see Command 50).