Installation
Type 1: Hung window installation
1. Cut the adhesive foam seal A and B strips to
the proper lengths, and attach them to the
window sash and frame as shown Fig.1.
Foam seal B
(Adhesive type-shorter)
Foam seal A
(Adhesive type)
Fig.1
2. Insert the window slider assembly into the
window track. If the hose opening is covered
by the lip of the window frame, rotate the
panel so the thicker side faces the window
frame.(see Fig.2)
For some units, attach the Window Kit Brace
to the back of the hose panel to brace against
the window so the window slider panels do
not lean inward. (see Fig.3)
3. Cut the non-adhesive foam seal C strip to
match the width of the window. Insert the
seal between the glass and the window
frame to prevent air and insects from getting
into the room.(see Fig.4)
4. If desired, install the security bracket with 2
screws as shown.(see Fig.5)
Window slider
(if required)
Window
slider
Fig.2
Window
Kit Brace
Fig.3
Foam seal C
(Non-adhesive type)
Fig.4
Security Bracket
2 Screws
Fig.5
Page 14
Installation
Instructions
Summary of Contents for CH-STLS-14AC
Page 27: ......
