3. Insert the window slider assembly into the
window track. If the hose opening is covered
by the window frame, rotate the panel so the
thicker side faces the window frame. (see Fig.9)
For some units, attach the Window Kit Brace
to the back of the hose panel to brace against
the window so the window slider panels do
not lean inward.(see Fig.10)
Window slider A
Window slider B
(if required)
Fig.9
Fig.10
Window
Kit Brace
4. Be sure bolts are installed in both sides of the
window slider for improved rigidity.
5. Cut the non-adhesive foam seal C strip to match
the window height. Insert the foam seal between
the glass and the window frame to prevent air
and insects from getting into the room.(see Fig.11)
Fig.11
Foam seal C
(Non-adhesive type)
6. If desired, install the security bracket with 2 screws
as shown.(see Fig.12)
2 Screws
Security
Bracket
Fig.12
7. Attach the Sliding Window Adapter to the hose by
lining up the circles on the adapter the hose. Insert
the window slider adapter into the hole of the window
slider.(see Fig.13)
Fig.13
Installation
Instructions
Page 16
Summary of Contents for CH-STLS-14AC
Page 27: ......
