SYSTEM PROGRAMMING AND SETTING
28
To program users list (see item 2.3) enter the following command in SMS text:
USERx C a M b
or
USERx C a M b ''+……''
where
C, M
– latin letters
x
= (1 - 5) - user order number
а
= (0 - 9) - digits which correspond to alarm/service notifications on which system will call
b
= (0 - 9) - digits which correspond to alarm/service notifications on which system will send SMS
+……
- user x phone number
The list of system alarm/service notifications
Alarm/service notification cause
Cause to call C
(value a)
Cause to send SMS M
(value b)
«Call» button is pressed
0
0
Ignition input is active. PIN-code fitting attempt. Power supply
12V disappeared
1
1
Door/hood/trunk terminal switch was triggered. External siren
input is active
2
2
Additional/shock/motion/inclination/glass brake sensor was
actuated
3
3
Universal terminal switch was actuated. Remote engine start
is failed
5
5
Battery is low. System account balance is lower than critical
6
GSM-network signal is disappeared/appeared
7
System is disarmed
8
8
System is armed
9
9
If there is no letters C or M in command GSM-system will save previous list of alarm/service notifications
for the users.
After receipt of SMS with this command system will send report with correspondent user (users) settings
confirmation:
USERx Call: а
and/or
SMS: b +……
where
x
= (1 - 5) - user order number
а, b
- the list of alarm/service notifications on which system will call and/or send SMS to the user
+……
- user x phone number
By reason of ignition activation from the list of alarm/service notifications (1) call or SMS sending will
be performed after one of alarm cycles until system disarming, low battery or when account balance is zero.
GSM-system will not call users on by reasons 6 and 7 from the list of alarm/service notifications even if
these reasons are specified during programming of the users list (C67).
Example:
If SMS will have text: «
PIN:0000 USER1 C0123 M7
» this mean that system will call user 1 (from phone
number of which SMS was sent) on the following causes:
0
- «Call» alarm button is pressed
1
- ignition is started, battery is disconnected, system power supply was disappeared
2
- doors, hood, trunk open
3
- sensor triggering
And send SMS on the following cause:
7
- GSM-network signal is disappeared/appeared
During users list programming you are able to program several users simultaneously using one SMS, text of
which includes not more than 120 symbols.
Example:
PIN:0000 USER1 C0123 M7''+380671234567''
USER2 C123 M789''+380677654321'' USER3 С123 М
If you need to change only user’s phone number without changing the list of his alarm/service events it is
necessary to send SMS from the new phone number:
