35
SYSTEM PROGRAMMING AND SETTING
Af ter receipt SMS with this command GSM-system will send the following report with confirmation of
activation/deactivation of system automatic rearming to number from which this SMS was sent:
REARM OFF
or
REARM ON
Note
If this function is implemented regularly in car, then automatic rearming will be made regardless value
x (only for model Convoy iGSM-005 CAN). If regular function is implemented within less than 30 seconds,
then GSM-system automatic rearming will not be done (even when x=1).
6.2.6 Setting time of terminal switches scanning delay
Setting this function enables to implement system arming delay due to time when compartment lighting
is on.
To specify time of terminal switches scanning delay (see clause 2.3) enter the following command:
ARMTIMER х
where
х
= (0 - 255) – time of terminal switches scanning delay in seconds.
Default setting – 15
Af ter receipt SMS with this command GSM-system will send the following report:
ARMTIMER х sec
6.2.7 Setting time of actual engine start check
Setting of this parameter enables to specify for system time interval after autostart activation and till
system should check engine start. To set this time interval after entering PIN-code (see clause 2.3) enter the
following command:
STARTTIMER x
where
x
= (1-1000) –delay time in seconds.
On default – 60
Af ter receipt SMS with this command GSM-system will send the following report:
STARTTIMER x sec
Note
Value x specified in command STARTTIMER should not exceed total time of all autostart attempts (plugs
heating-up time, operation time of starter and pause between start attempts).
6.2.8 Setting parameters of «Turbotimer” mode
If GSM-system is installed into car with turbo engine we recommend you to use «Turbotimer» mode and
set its parameters. To set this mode parameters enter the following command in SMS-text (see clause 2.3):
TURBOTIMER x y
where
х
= (0 - 255) – time of ignition pick-up ( time of system operation in «Turbotimer» mode) in minutes.
y
= (0 - 255) – time of ignition start when lockout is active in seconds, to exclude possible mistakes of on-
board computer. This parameter can be absent
Default settings x=0 («Turbotimer» mode is of f), y=0
Af ter receipt SMS with this command GSM-system will send the following report:
TURBOTIMER x min y sec
Note
If NO blocking is realized on any output (see sub-item 6.2.3) command
TURBOTIMER 02
(x=0,y=2)
allows avoiding on-board computer error while starting the engine in arming mode.
6.2.9 Setting “Immobilizer” mode
To activate/deactivate “Immobilizer” mode enter the following command in SMS-text (see clause 2.3):
AVFUN x
where
х
= 0 – deactivate passive lockout (deactivate “Immobilizer” mode)
х
= 1 –activate passive lockout (activate “Immobilizer” mode)
Default setting – 0 (“Immobilizer” mode is deactivated)
System will send the following SMS-report to number from which this SMS was sent:
AVFUN OFF
or
AVFUN ON
