37
SYSTEM PROGRAMMING AND SETTING
6.3.2 Setting mode
This mode allows built-in shock sensor adjusting, programming inputs and outputs of system for main
variants of its control and returning to factory settings.
To change system settings start the ignition.
Enter command number indicated in the table below. It is possible only if safety jumper is installed.
Command
number
Operation
Sound
0
Entering programming mode
LONG TRILL
4
Entering shock sensor warning zone setting mode by real shock
Long whistle with increased
frequency (15 seconds)
5
Entering shock sensor alarm zone setting mode by r eal shock
Long whistle with increased
frequency (15 seconds)
300
Return to default settings
KU-KA-RE-KU
301
Inputs/outputs setting when GSM-system controls regular CL (see sub-item
7.4.4.)
KU-KA-RE-KU
302
Inputs/outputs setting when GSM-system controls regular CL and system
cooperation with start module Convoy ARS-300 (see sub-item 7.4.4.)
KU-KA-RE-KU
303
Inputs/outputs setting when GSM-system controls additional security system
(see sub-item 7.4.5.)
KU-KA-RE-KU
304
Inputs/outputs setting when GSM-system controls additional security system
and system cooperation with start module Convoy ARS-300 (see sub-item 7.4.5.)
KU-KA-RE-KU
305
Inputs/outputs setting when GSM-system controlling at its independent
operation (control only from phone) (sub-item 7.4.6.)
KU-KA-RE-KU
306
Inputs/outputs setting when control GSM-system controlling at its independent
operation (control only from phone) and system cooperation with start module
Convoy ARS-300 (sub-item 7.4.6.)
KU-KA-RE-KU
other
Wrong command number is entered
BOO-BOO-BOO-BOOM
To adjust shock sensor select command 4 or 5. Built-in microspeaker warning signals will follow after
entering, during them leave your car without stopping ignition. During 8 seconds after warning signals stop
you should hit your car with required force. Then you will hear confirmation signal from microspeaker and
system will exit setting mode.
6.3.3 PIN-code input to enter programming mode
To change system hardware settings start the ignition.
Further you have two variants to change system settings:
1. Turn on ignition.
2. Using service button enter figure of 4 digits of whole system PIN-code.
If wrong PIN-code is entered system will play «
BOO-BOO-BOO-BOOM
» signal. If PIN-code is correct
system will play «
LONG TRILL
» signal and start programming mode.
6.3.4 Programming mode
This mode enables to change system hardware settings using service button. Setting is made by required
value change (is necessary).
To enter programming mode:
1. When safety jumper is installed enter command “0”, if jumper is removed – enter PIN-code. (see sub-
item 6.3.2).
You will hear «
LONG TRILL
» sound.
2. Enter function number which value you need to know or change (see table below).
If you enter number which does not correspond to any function you will hear «
BOO-BOO-BOO-BOOM
»
sound and system will return to entering another function number. If you enter existing function number,
speaker will inform you of current function status.
3. Enter new function value. If you don’t need to change function value wait 4 seconds till you hear
«
BOOM
» sound.
Function value change will be confirmed by «
KU-KA-RE-KU
» sound, saving of previous value – with
«
BOOM
» sound. In both cases you can enter new function number.
To change another function value repeat clauses 2 and 3.
To exit system programming mode stop ignition or during 16 seconds do not fulfill any operations. System
