Rev. d 01/1 21
DMP052E
Parameters Loop
P d 1
- Mode D3
The Parameter menu of On/OFF Hysteresis Digital operating Mode D3 is the sum of D1/D2 Modes
parameter menus. This Menu contains all parameters, since this mode is intended to manage both
heating and cooling control loops.
Push
Set
key to select the parameter to be modified. The parameter value blinks showing the edit
status: push the
Up
and
Down
keys to change values. Once the desired values are modified, push
the
Set
or
Esc
keys to exit. The Compensation and Limit parameters are visible if the relevant
functions in the Operating Mode Programme menu (2
nd
Level) are enabled. Push
Set
key for 10
seconds to enter such menu.
Sequence Parameters
P d 1
and
P d 2
- Mode D4
Push
Set
key to select the parameter to be modified. The parameter value blinks showing the edit
status: push the
Up
and
Down
keys to change values. Once the desired values are modified, push
the
Set
or
Esc
keys to exit.
Parameters Loop
P A 2
- Mode A1
Push
Set
key to select the parameter to be modified. The parameter value blinks showing the edit
status: push the
Up
and
Down
keys to change values. Once the desired values are modified, push
the
Set
or
Esc
keys to exit.
Humidification Operating Set-point (read-only)
Minimum Set-point of humidification compensation
Minimum temperature of humidification compensation
S o H
S c 1
t c 1
Max Set-point of humidification compensation
Max temperature of humidification compensation
Humidification proportional Band
S c 2
t c 2
b P H
Humidification integral time
t i H
Visible only with compensation on (coP parameter = On )
Visible only with integral On ( int parameter = On )
S
Humidification Set-point
S t H
Visible only with compensation off ( coP parameter= Off )
