![background image](http://html1.mh-extra.com/html/conrad/gx103-gps/gx103-gps_operating-instructions-manual_2653965021.webp)
21
2. Setting Support (Command “DIAGNOSE”)
For the sensors to be easier to configure, this command was introduced. After activation, this function controls the LEDs of the three buttons “1”,
“2” and “3” in the “ALARM DISABLE” mode, as well as the speaker. When a sensor recognises something in its current sensitivity setting, the
speaker will emit a short beep and the corresponding LED flashes. Assignment of the three LEDs in the buttons and sensors is fixed and cannot
be changed:
LED in button “1” (8) = MOVE
LED in button “2” (9) = SHOCK
LED in button “3” (10) = MIC
The following command is used to activate this function:
SET DIAGNOSE #1513
The following command is used to deactivate this function:
RESET DIAGNOSE #1513
There is no “TEST” command for this command.
3. External Voltage Source / USB Plug Monitor (USB)
This function can be used to recognise unplugging or failure of the external voltage source (USB mains adapter or PC). Once the USB supply
voltage fails, this can be configured as reason for the alarm. The following command is needed for this.
Activation of the USB monitoring:
SET USB #1513
Stop monitoring:
RESET USB #1513
4. Assigning Functions to the Buttons “1”, “2” and “3” (Commands “KEY1”, “KEY2”, “KEY3”, “KEYALL”)
The buttons labelled “1”, “2” and “3” can be assigned various functions. In the delivery condition, neither of these buttons has a function. Only in
case of a phone call (incoming or outgoing) do the buttons have the following additional task:
Function: Call (incoming / outgoing)
Button “1”: hanging up or rejecting call
Button “2”: activating speaker/hands free function
Button “3”: accepting call
In regular condition (without phone call), the buttons can be assigned other functions as follows:
SET KEY1 <Function> #1513
SET KEY2 <Function> #1513
SET KEY3 <Function> #1513
The current status can be determined with the following command:
TEST KEY #1513
The following command is used to delete the functions:
RESET KEY1 #1513
RESET KEY2 #1513
RESET KEY3 #1513
You can also delete all three settings together. Use the following command:
RESET KEYALL #1513
Summary of Contents for GX103+GPS
Page 35: ...35...