Conrad GX103+GPS, Operating Instructions Manual, Page: 22 / 36

22
The following functions are possible:
• Function: Phone number
You may assign a phone number to either of the three buttons. If you want to assign the phone number 015112233… to button “1”, the
command is:
SET KEY1 TEL +4915112233… #1513
• Function: Switching sensor activation
You can use the buttons to manually activate and deactivate the individual sensors as well. Switching only works in the module “ALARM
DISABLE”, of course, since an alarm is activated otherwise. if you want to assign a sensor to button “2”, the command is:
SET KEY2 SHOCK #1513
SET KEY2 MOVE #1513
SET KEY2 VOICE #1513
If one of the buttons is pushed in the regular condition, the corresponding sensor is activated. This is signalled by the button’s LED being lit. To
deactivate the sensor again, the button must be pushed again. the LED in the button signals the current sensor status. The LED will switch off
again after no more than 30 s in any case.
The corresponding sensor configuration is used for the next “ALARM ENABLE”.
The sensors are activated with the setting (sensitivity) that was configured last with the corresponding command.
• Function: Control of the tracking function
You can use the button to control the tracking function. After pushing the button, the tracking function is always activated or remains active.
This is signalled by the button’s LED being lit. If the button is pushed again within 30 s, the tracking function and key backlighting switch off.
Pushing button again switches the function on again.
Example: The following command is used to couple the button “3” to this function:
SET KEY3 GPSTRACK #1513

The last configuration set for the command “TRACK” is used.
If nothing was set yet, the command “TRACK” is activated with the parameters 30 s and no RING buffer.