Operating Instructions
Single-pole Conductor Rail System
SingleFlexLine Program 0815
BAL0815-0002g-US
www.conductix.us
translated document
page 74 of 128
→
Slide the connector cap (Pos. 4) over the clamping unit (see Fig. 87). Ensure that the connector cap (Pos. 4) only fits over the
clamping unit from one side, e.g., the higher side (Pos. A) of the connector cap (Pos. 4) must point in the direction in which the
expansion module is to be mounted (see Fig. 81 and Fig. 80).
Fig. 87: Slide connector cap (Pos. 4) over the clamping unit of the connector
→
Hang the next conductor rail poles in the hanger clamp and carefully tap the other conductor rail poles into the clamping unit of
the connector (see Fig. 88) with light taps (tool: plastic hammer) and tighten the cylinder screw of the clamping unit (Pos. 5) with
the specified torque (torque wrench:
2 Nm
, SW3) (see Fig. 89).
Fig. 88: Tap the other conductor rail poles into the clamping unit of the
connector with a plastic hammer
Fig. 89: Tighten the cylinder screw of the clamping unit
4
