Operating Instructions
Single-pole Conductor Rail System
SingleFlexLine Program 0815
BAL0815-0002g-US
www.conductix.us
translated document
page 44 of 128
Required tools:
Bending device 081091
Work steps:
→
Scribe the required bend on a flat surface (e.g., the floor).
→
When making horizontal bends: Insert the plastic insert in the slot on the conductor rail contact surface with the insulating profile
slid open.
→
Using the setting spindle, move the upper bending roller upward until the rail section can be inserted into the recess provided in
the bending device.
→
Adjust the position of the bending roller downward and move the rail section back and forth.
→
Bend the rail section by progressively advancing the central pressure roller.
→
Repeat this process until the required radius is achieved.
→
All subsequent rail sections that are to be formed to the same radius can now be bent using the existing setting.
→
The rollers are designed for the various bends (horizontal/vertical, see BAL0800-0004 for the bending device for product ranges
0811 and 0815).
NOTE!
Use modified PE
plus
rails for conductor rail bends with radii < 1500 mm!
→
Use modified PE
plus
rails (Order No.: 081516-4x15) for preparing conductor rail bends with radii <
1500 mm.
These rails are slotted on the rear side and can be bent without deformation of the insulation.
Fig. 31: Slotted PE
plus
rail
Fig. 32: Bending device (081091)
Use the QR code (“click” or “scan”), to watch our animation
Bending Rails.
