3-10
I
Installation
Initial Setup
r
Operating Mode
r
Temperature Units
r
Setpoint
r
Alarm Points
CAUTION:
The Thermolator will not operate correctly if certain factory-set
parameters are changed. Parameters should only be changed by qualified
technical personnel who are familiar with the operation of this type of equipment.
If the Thermolator does not appear to be working correctly, verify the parameters
against the list of factory settings.
For a complete list of the factory-set parameters
see Default Parameters in the appendix of
this user guide.
All parameters can be changed using the keypad and the menu system.
(Continued)
Mold
Purge
Rapid
Cool
Process
Cool Down
Control Power
Autostart Signal
Pump
Heat
Cool
Coolant Pressure
Temperature Limit
Electrical Phase Error
Heat Error
Process Cool Down
Rapid Cool
Communications
Remote Heat/Cool
Program Mode
Mold Purge
Flow GPM (flash)
Raise Key
Used to increase values or toggle between setting choices.
Lower Key
Used to decrease values or toggle between setting choices.
Select Key
Used to select a parameter for editing, or save the new
value of a changed parameter.
Configuration Menu
Summary of Contents for Thermolator TW-P
