Description
I
2-7
2
Description
TW-P Control Features vs TW-V and TW-S
Model
TW-P
Direct Injection
Closed Circuit - Common Source
Closed Circuit - Separate Source
Construction
Standard Pump Range
3/4 to 10 Hp
{0.56 to 7.45 KW}
Standard Heater Range
0 to 48 KW
Cast Heater / Pump
Incoloy Heaters
Silicon Carbide Seals
Pressure Gauges
250°F Setpoint Range
300°F Setpoint Range
Controls
PID Control
Setpoint / Actual Display
Password Protection
Modbus RTU via RS-485
SPI via RS-485
Retransmit Process Temp (4-20mA)
Hand Held Remote
Auto Restart Capability
High Temperature Safety
Mold Purge
Phase Detection Circuit
Heat Error for Heater Malfunction
Remote Start/Stop
120°F Air Purge Cancel
Quick Access Cool Down Mode
Status / Alarm Lights
Panel Mounted Status Lights
12 LEDs
Panel Mounted Alarm Lights
5 LEDs
Audible Alarm
Strobe Light
Model
TW-S
TW-V
Direct Injection
Closed Circuit - Common Source
Closed Circuit - Separate Source
Construction
Standard Pump Range
3/4 to 10 Hp
{0.56 to 7.45 KW}
3/4 to 10 Hp
{0.56 to 7.45 KW}
Standard Heater Range
0 to 48 KW
12 KW
Cast Heater / Pump
Incoloy Heaters
Silicon Carbide Seals
Pressure Gauges
250°F Setpoint Range
300°F Setpoint Range
Controls
PID Control
Setpoint / Actual Display
Password Protection
Modbus RTU via RS-485
SPI via RS-485
Retransmit Process Temp (4-20mA)
Hand Held Remote
Auto Restart Capability
High Temperature Safety
Mold Purge
Phase Detection Circuit
Heat Error for Heater Malfunction
Remote Start/Stop
120°F Air Purge Cancel
Quick Access Cool Down Mode
Status / Alarm Lights
Panel Mounted Status Lights
7 LEDs
1 LED
Panel Mounted Alarm Lights
3 LEDs
1 LED
Audible Alarm
Strobe Light
The TW-P Control
Mold
Purge
Rapid
Cool
Process
Cool Down
Control Power
Autostart Signal
Pump
Heat
Cool
Coolant Pressure
Temperature Limit
Electrical Phase Error
Heat Error
Process Cool Down
Rapid Cool
Communications
Remote Heat/Cool
Program Mode
Mold Purge
Flow GPM (flash)
Control features on the TW-P Series Thermolators
Control features on the TW-S and TW-V Series Thermolators
PID Control
Purge On/
Off button
included on
control.
Phase
detection
indicates
incorrect
pump rotation
or an open
electrical leg.
Remote Start/
Stop works
with external
timers or
switches for
convenient
preheating of
molds.
Standard
Optional
* 4-20mA
Summary of Contents for Thermolator TW-P
