3-12
I
Installation
Setpoint
To select the proper setpoint of the system, follow this procedure:
1
From the home screen you should observe the current setpoint
in green in the up-
per display and the actual process temperature in the lower window.
2
Change the setpoint using the “Up”
or “Down”
buttons.
The new
value will automatically be implemented a few seconds after the up or down button is
released.
NOTE
: From the factory, the TW-P will control the “To Process” or “Supply” fluid to the setpoint.
Mold
Purge
Rapid
Cool
Process
Cool Down
Control Power
Autostart Signal
Pump
Heat
Cool
Coolant Pressure
Temperature Limit
Electrical Phase Error
Heat Error
Process Cool Down
Rapid Cool
Communications
Remote Heat/Cool
Program Mode
Mold Purge
Flow GPM (flash)
Adjust setpoint upwards
Adjust setpoint downwards
Process value
Setpoint value
Summary of Contents for Thermolator TW-P
