Operation
I
4-21
4
Opera
tion
Conair TW-P Thermolator
Normal Operation
For normal operation of the TW-P Thermolator, set the setpoint on the temperature
controller using the
and
buttons. On the display, the lower red display shows
the current temperature, and the upper green display shows the setpoint. In the right-hand
column, the various LEDs describe the status of the machine.
Mold
Purge
Rapid
Cool
Process
Cool Down
Control Power
Autostart Signal
Pump
Heat
Cool
Coolant Pressure
Temperature Limit
Electrical Phase Error
Heat Error
Process Cool Down
Rapid Cool
Communications
Remote Heat/Cool
Program Mode
Mold Purge
Flow GPM (flash)
(Continued)
Adjust setpoint upwards
Adjust setpoint downwards
Process value
Setpoint value
Summary of Contents for Thermolator TW-P
