Conair Carousel Plus W Series, User Manual, Page: 10 / 193

1 - 4 l I n t r o d u c t i o n
AT T E N T I O N :
R e a d T h i s S o N o O n e G e t s H u r t
We design equipment with the user’s safety in mind. You can avoid the potential hazards
identified on this machine by following the procedures outlined below and elsewhere in the
User Guide.
W A R N I N G : I m p r o p e r i n s t a l l a t i o n , o p e r a t i o n , o r s e r v -
i c i n g m a y r e s u l t i n e q u i p m e n t d a m a g e o r p e r s o n a l
i n j u r y.
This equipment should be installed, adjusted, and serviced by qualified techni-
cal personnel who are familiar with the construction, operation, and potential
hazards of this type of machine.
All wiring, disconnects, and fuses should be installed by qualified electrical
technicians in accordance with electrical codes in your region. Always maintain
a safe ground. Do not operate the equipment at power levels other than what is
specified on the machine serial tag and data plate.
W A R N I N G : V o l t a g e h a z a r d
This equipment is powered by three-phase alternating current, as specified on
the machine serial tag and data plate.
A properly sized conductive ground wire from the incoming power supply must
be connected to the chassis ground terminal inside the electrical enclosure.
Improper grounding can result in severe personal injury and erratic machine
operation.
Always disconnect and lock out the incoming main power source before open-
ing the electrical enclosure or performing non-standard operating procedures,
such as routine maintenance. Only qualified personnel should perform trou-
bleshooting procedures that require access to the electrical enclosure while
power is on.