14
COMUNELLO
®Copyright 2014 - All right reserved
PRESCRIPTIONS
• The control unit is not equipped with a device for
disconnection of the 110 ~ power supply line. It
is therefore the responsibility of the installer to fit
a disconnection device in the electrical system.
The disconnection device must be composed of
a category III overvoltage all-pole circuit breaker.
This device must be positioned in consideration
of the need to be protected against inadvertent
reconnection in compliance with the requirements
of EN 12453 point 5.2.9. Wiring of the external
electrical devices to the control unit must be carried
out in compliance with the prescriptions of EN
60204-1 as amended by EN 12453 point 5.2.7.
The maximum diameter of power feeding cables
is 14 mm; fixing of power feeding and connection
cables must be assured by fitting cable glands,
which can be supplied as optionals.
• The power input cables must be of the standardized
flexible type with polychloroprene sheath (H05RN-F)
having minimum conductor size of 1 mm
2
.
• During the installation operations, take care to use
cable with double insulation only (sheathed cables)
for both of mains voltage connections (110V)
and extra-low voltage connections (SELV). Use
exclusively plastic cable trays, separated for mains
voltage wiring (110V) and extra-low voltage wiring
(SELV).
• The extra low voltage conductors must be physically
separated (at least 4 mm in air) from the mains
voltage wires, or shall be adequately insulated with
extra insulation with a thickness of at least 1 mm.
• Upstream of main supply, install a device that
ensures the complete omnipolar disconnection
(cut-off switch) of the power supply, with a contact
opening gap of at least 3mm in each pole. These
disconnecting devices shall be places in the power
supply wiring in compliance with the installation
standards and must be directly connected to the
supply terminals.
• When drilling the outer case to insert the power
and connection cables and when fitting the cable
glands, take care to install all the parts in a manner
that maintains the IP protection characteristics of
the box unchanged as far as possible. Ensure the
cables are fixed in a stable and secure manner.
• The rear of the box is equipped with knockouts
for wall fixing (knockouts for fixing holes using
anchor bolts or holes for fixing with screws). Take
all the measures required to ensure the installation
procedures do not affect the IP rating.
• If required, a pushbutton panel for manual control
of the gate must be installed in a position such as
to ensure the user is not placed in danger.
• The operator utilized to move the gate must be in
compliance with the prescriptions of EN 12453,
point 5.2.7.
• Power Supply output D.S. must be used for
photocells. Alternative uses of this output are not
permitted.
• At each operating cycle, the control unit can test
the photocells operation to ensure protection
against failure of anti-crushing protective devices
according to Category 2 in compliance with the
prescriptions of EN 12453 point 5.1.1.6. It follows
that if the safety devices are not connected or are
faulty, operation of the control unit will be inhibited.
• The device can be used by children no older than
8 years old and people with reduced physical,
sensory or mental capabilities, or lack of experience
or without the required knowledge, but only under
surveillance or after having received instructions
about the safe use of the device and the hazards
inherent in it. Children should not play with the
device. Cleaning and maintenance should not be
carried out by children without supervision.
For correct operation of the radio receiver section,
when using two or more control units it is good
practice to install them at a minimum distance of 3
metres from one another.
All operations that require the control unit box to be
opened (connection of cables, programming, etc.)
must be carried out by expert personnel at the time
of installation. For all further operations that require the
box to be re-opened
IMPORTANT INFORMATION FOR USERS
• The device must not be used by minors or
psychologically-physically differently-abled persons
unless they are supervised or duly instructed on
the operation and methods of use.
• Do not let children play with the device and keep
the remotes out of their reach.
•
IMPORTANT:
keep this instruction manual and
comply with the safety prescriptions set down
herein. Failure to comply with the prescriptions may
cause damage and serious accidents.
Frequently examine the system to identify any signs of
damage. Do not use the device if repairs are required.
