Compuprint 4247 X03, User Manual

Page: 123 / 200

Table 14. Single Path Usage recommendations
Operation No. Users Tear Off Auto Eject Auto Restore
Single Path 1 On Demand Disabled Data or Timer
Single Path 1 Constant Enabled Data or Timer
Single Path 2 or more On Demand Disabled Timer
Single Path 2 or more Constant Enabled Timer
Note: The combination of settings with Automatic Eject = Enabled and Automatic Restore
= Disabled is not recommended.
Table 15. Dual Path Usage recommendations
Operation No. Users Tear Off Auto Eject Auto Restore
Dual Push 1 On Demand Disabled Data
Dual Push 1 Constant Enabled Data
Dual Push 2 or more On Demand Disabled Data
Dual Push 2 or more Constant Enabled Data
Note: The combination of settings with Automatic Eject = Enabled and Automatic Restore
= Disabled is not recommended.
Automatic Eject
This parameter is displayed for the Front Push or Rear Push forms path. You can
set the printer to perform an automatic eject without pressing
LOAD/EJECT when
a print job is complete.
You can set this value to:
Enabled When the print job is complete, the printer will
perform an automatic eject after a fixed timeout of
approximately 5 seconds.
Disabled (Default) No automatic eject. The LOAD/EJECT is required
to eject the forms.
To change or check the automatic eject after timeout, follow these steps:
1.
Press MENU .
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Setup
3. Press ENTER .
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Setup
Automatic Eject
5. Press ENTER to display the current value.
6.
Press SCROLL/MICRO or SCROLL/MICRO until the desired value for the
Automatic Eject is displayed.
7. Press ENTER .
An asterisk (*) will be displayed in front of the selected value.
Chapter 8. Printer setup
107