AlphaBIOS Firmware
8-39
If Windows NT was installed at the factory, enter Windows NT setup as described in
Section 8.4. If it was not installed, or if you are installing another version, you must
have a CD-ROM drive attached to your system.
If this is a new Windows NT installation, start with this procedure:
1. Start AlphaBIOS. If the system is in the SRM console, issue the command
alphabios.
2. Enter
AlphaBIOS Setup by pressing the F2 key before the operating system
boots.
3. From
AlphaBios Setup, select CMOS Setup, and press Enter.
4. From
CMOS Setup, set the system date and time.
5. Return to the AlphaBIOS Setup screen by pressing the F10 key.
6. Select
Hard Disk Setup and press Enter.
7. Select and format all disks. See Section 8.7 for information on formatting hard
disks.
8. Continue the setup by pressing the F10 key.
9. Go to the procedure below.
This procedure is for all Windows NT installations:
1. Put the Windows NT CD into the CD-ROM drive.
2. Enter
AlphaBIOS Setup.
3. Select
Install Windows NT and press Enter.
4. Follow the prompts to complete the installation. For more information on
installing Windows NT, refer to the Installation Guide in your Windows NT
software package.
