. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-12
Overview of Installing ProLiant 2500R Server and Hardware Options
Writer:
BETTYD
Project:
Overview of Installing ProLiant 2500R Server and Hardware Options
Comments:
Rack chapter for Brenda Pereira's Guide
File Name:
G_CH04.DOC
Last Saved On:
8/2/96 10:57 AM
4. Lay the bracket rail inside the mounting bracket with the front of both
pieces oriented in the same direction. Align the front screw holes in the
mounting bracket and the bracket rail.
To identify the front of the mounting bracket and the bracket rail:
❏
The front of the mounting bracket has alignment tabs on its flange.
❏
The front of the bracket rail allows the inner slide to move forward
on ball bearings.
5. Extend the inner slide from the front of the bracket rail. With this piece
extended, you will see two screw holes aligned in the mounting bracket
and the bracket rail. These are the two exposed holes near the back end
of the bracket rail and the front hole accessible through a slot in the
inner slide.
6. Fasten the bracket rail to the mounting bracket with two 8-32 x 1/4-inch
slotted screws.
(Do not use nuts or washers with the screws.) See step
of the following figure.
7. Adjust the inner slide to access the other two screw holes, one at a time,
through the slotted opening in the inner slide. Use two more 8-32 x 1/4-
inch slotted screws to fasten the bracket rail to the mounting bracket.
See steps
and
of the following figure.
The following figure shows inserting the screws into the appropriate holes. The
screws will line up with the 22-inch markings stamped along one edge of the
mounting bracket. These marks identify the mounting holes for the 22-inch
slides used in Compaq racks. (The 24-inch markings stamped along the other
edge are for use with the 24-inch slides that support other components.)
