. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
C-1
Compaq ProLiant 2500 Servers Installation Guide
Writer:
B J Pereira
Project:
Power Cord Set Requirements
Comments:
File Name:
J_APPC.DOC
Last Saved On:
8/2/96 11:00 AM
Appendix C
Power Cord Set Requirements
The power cord set meets the requirements for use in the country where you
purchased your equipment. The voltage selection switch allows you to select
the appropriate line voltage for your server.
Power cord sets for use in other countries must meet the requirements of the
country where you use the server. For more information on power cord set
requirements, contact your Authorized Compaq Dealer.
General Requirements
The requirements listed below are applicable to all countries:
■
The length of the power cord must be at least 6.00 feet (1.8 m) and a
maximum of 8 feet (2.4 m).
■
The power cord set must be approved by an acceptable accredited
agency responsible for evaluation in the country where the power cord
will be used.
■
The power cord set must have a minimum current capacity and nominal
voltage rating of 10 A, 125 volts AC or 10A, 250 volts
AC, as required by each country’s power system.
