. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-7
Compaq ProLiant 2500 Servers Installation Guide
Writer:
B J Pereira
Project:
Overview of Installing ProLiant 2500 Server and Hardware Options
Comments:
File Name:
F_CH03.DOC
Last Saved On:
8/23/96 2:35 PM
Removing Side Access Panel to Locate
Internal Wiring and Hood Labels
To remove the Side Access Panel:
1. If the computer is on, turn it off and disconnect the power cord.
2. Disconnect any other external equipment connected to the computer.
3. Open the Front Bezel.
4. Loosen the two thumbscrews located on the left side of the front chassis.
5. Slide the Side Access Panel toward the rear of the unit 0.5 inch (1.5 cm).
6. Lift and remove the panel.
CAUTION:
Do not operate the server with the Side Access Panel removed.
The Side Access Panel is an integral part of the cooling system and
removing it while the system is running may adversely affect data integrity.
CZR-003.EPS
Figure 3-3.
Removing the Side Access Panel
7. Turn the Side Access Panel over to locate the Processor Board and the
Drive Configuration Hood Labels.
NOTE:
These labels provide information on installing processor board
options, configuring drives, installing drives, and setting switches.
