INS_CWGE24MS2_REV–
10/05/16 PAGE 215
INSTALLATION AND OPERATION MANUAL
CWGE24MS2
TECH SUPPORT: 1.888.678.9427
Web Configuration
Parameter
Description
State
Use this to Enable or Disable ARP inspection on the Switch.
VLAN State
Enter the VLAN IDs you want the Switch to enable ARP Inspection for. You can designate
multiple VLANs individually by using a comma (,) and by range with a hyphen (-).
Trusted Ports
Select the ports which are trusted and deselect the ports which are untrusted.
The Switch does not discard ARP packets on trusted ports for any reason.
The Switch discards ARP packets on untrusted ports in the following situations:
• The sender’s information in the ARP packet does not match any of the current bindings.
• The rate at which ARP packets arrive is too high. You can specify the maximum rate
at which ARP packets can arrive on untrusted ports.
Select All
Click this to set all ports to trusted.
Deselect All
Click this to set all ports to untrusted.
Apply
Click Apply to add/modify the settings.
Refresh
Click Refresh to begin configuring this screen afresh.
ARP Inspection Status
ARP Inspection StateThis field displays the current status of the ARP Inspection feature, Enabled or Disabled.
Enabled on VLAN
This field displays the VLAN IDs that have ARP Inspection enabled on them. This will
display None if no VLANs have been set.
Trusted Ports
This field displays the ports which are trusted. This will display None if no ports are
trusted.
