INS_CWGE24MS2_REV–
10/05/16 PAGE 147
INSTALLATION AND OPERATION MANUAL
CWGE24MS2
TECH SUPPORT: 1.888.678.9427
Port Priority:
The port priority determines which ports should be put in standby mode when there is a hardware
limitation that prevents all compatible ports from aggregating.
Default Settings
The default System Priority is 32768.
The default group LACP state is disabled for all groups.
CLI Configuration
Node
Command
Description
enable
show lacp counters
[GROUP_ID]
This command displays the LACP counters for the specific group or
all groups.
enable
show lacp internal
[GROUP_ID]
This command displays the LACP internal information for the
specific group or all groups.
enable
show lacp neighbor
[GROUP_ID]
This command displays the LACP neighbor’s information for the
specific group or all groups.
enable
show lacp port_priority This command c displays the port priority for the LACP.
enable
show lacp sys_id
This command displays the actor’s and partner’s system ID.
configure
lacp (disable | enable)
This command disables / enables the LACP on the switch.
configure
lacp GROUP_ID (disable |
enable)
This command disables / enables the LACP on the specific trunk
group.
configure
clear lacp counters
[PORT_ID]
This command clears the LACP statistics for the specific port or all
ports.
configure
lacp system-priority
<1-65535>
This command configures the system priority for the LACP. Note:
The default value is 32768.
configure
no lacp system-priority
This command configures the default for the system priority for the
LACP.
interface
lacp port_priority
<1-65535>
This command configures the priority for the specific port.
Note: The default value is 32768.
interface
no lacp port_priority
This command configures the default for the priority for the specific
port.
configure
interface range
gigabitethernet1/0/
PORTLISTS
This command enters the interface configure node.
if-range
lacp port_priority
<1-65535>
This command configures the priority for the specific ports.
Note: The default value is 32768.
if-range
no lacp port_priority
This command configures the default for the priority for the specific
ports.
