INS_CWGE24MS2_REV–
10/05/16 PAGE 158
INSTALLATION AND OPERATION MANUAL
CWGE24MS2
TECH SUPPORT: 1.888.678.9427
Parameter
Description
State
Select this option to enable loop guard on the Switch.
MAC Address
Enter the destination MAC address the probe packets will be sent to. If the port
receives these same packets the port will be shut down.
Port
Select a port on which to configure loop guard protection.
State
Select Enable to use the loop guard feature on the Switch.
Loop Recovery
Select Enable to reactivate the port automatically after the designated recovery time
has passed.
Recovery Time
Specify the recovery time in minutes that the Switch will wait before reactivating the
port. This can be between 1 to 60 minutes.
Apply
Click Apply to save your changes to the Switch.
Refresh
Click Refresh to begin configuring this screen afresh.
Loop Guard Status
Port
This field displays a port number.
State
This field displays if the loop guard feature is enabled.
Status
This field displays if the port is blocked.
Loop Recovery
This field displays if the loop recovery feature is enabled.
Recovery
Time (min)
This field displays the recovery time for the loop recovery feature.
