CommPact Control system, Installation Manual

Page: 95 / 148

Appendix B: Transmitter Installation
CommPact Installation Manual
91
Figure B- 4: EL-2650XL (Cover Off)
Location of Detector
Consider the following before mounting the detector:
•
Select a location from which the pattern of the detector is most likely to be crossed by
a burglar, should there be a break in.
•
Avoid a location that comes in direct contact with radiators, heating/cooling ducts or
air conditioners.
•
Do not place bulky objects in front of the detector.
Do not install the detector above beds, sofas, desks or in any area that people are likely to
spend continued periods of time. If the occupant does not move within the delay time, an
alarm will be generated when moving away from the protected area.
Figure B- 5: Correct Placement of the Detector
Installation Instructions
1. To open the housing, remove the cover screw and, using a flathead screwdriver, press
the locking tab at the side of the unit. Remove the Main Board by unscrewing the PCB
screw.
Do not touch the face of the PYRO sensor.
2. Set the receiver to Registration mode. Apply battery power by removing the isolator that
separates the battery from the contacts on the battery holder. The detector turns on and
sends four transmissions in order to be registered with the system. Wait for the receiver to
indicate that the transmitter has been registered successfully. Alternatively, the EL-2650XL
can be registered to the receiver by manually entering the transmitter's serial number.
LED
Indicator
PCB Screw
Tamper
Switch
Pyro Sensor
Mode
Jumper
Alarm Delay
Jumper
Battery
Holder
LED
Jumper
PCB
Adjustment
Scale