Appendix B: Transmitter Installation
CommPact Installation Manual
132
10.
Set the control system to Registration mode as follows:
o
From the Programming menu, select Devices, Sounder, Register [9151].
o
Set the sounder to Transmission mode by placing the Mode jumper (JP1) as
shown in Figure B- 49; the sounder transmits a signal every few seconds.
Figure B- 49: Mode Jumper Configuration
o
When Save? appears on the control system’s LCD display, press '
√ʹ
on the control
system’s keypad.
11.
Remove the Mode jumper on the sounder and place it over one pin for storage and
disconnect the power supply.
12.
Configure the Setting Tones jumper (JP2) as required. If the jumper is removed, the
sounder sounds tones and flashes the strobe on set/unset. If the jumper is installed, the
sounder flashes the strobe on set/unset but no tones are sounded.
13.
Choose a suitable mounting position for the sounder. The sounder should be mounted on
a flat surface in a highly visible position for maximum deterrence against potential
intruders.
14.
Before permanently mounting the sounder, test the reception from the exact mounting
position. If necessary, relocate the sounder to a better position.
15.
To mount the EL-2626AC, place the back cover in position against the wall and mark the
upper and lower mounting holes. Install wall anchors in the appropriate positions.
16.
Thread the cables through the cable entry hole on the back cover and mount the back
cover to the wall using four screws.
17.
Connect the transformer to the terminal block and the backup battery to the battery
connector. If using Electronics Line 3000’s tamper protected external power supply,
connect its tamper output to the sounder’s external tamper input, remove the External
Tamper jumper and place it over one pin for storage – see Figure B- 48 for further
information on wiring connections and Figure B- 47 for the location of the External
Tamper jumper.
18.
Replace the metal anti-vandal casing and the strobe cover.
19.
Replace the front cover and secure using the cover screw provided. Make certain that the
screw is secured tightly so that it closes the front cover tamper switch.
Signals and Messages
In case of a low battery (2.5 V and below), the detector low battery condition is reported to the
Control System and low battery message is displayed.
When the rear tamper switch is released, the detector sends a tamper condition to the Control
System that generates tamper alarm.
TRANSMISSION MODE ►
REGISTRATION MODE ►
Summary of Contents for Control system
