10 Communications
CommPact Installation Manual
72
10.7.5. SMS
Confirmation
After an SMS command is executed by the system, a confirmation message is returned to the
sender’s mobile phone. You can enable or disable this feature using this option.
To enable/disable SMS confirmation:
1.
From the Programming menu, select Communications, Comm. Options, GSM Options,
and SMS Confirm [954135].
2.
Select Enabled or Disabled.
10.7.6. GSM Media Loss Time
The GSM Media Loss Time is a feature that is designed to control the amount of GSM media loss
events registered in the log and sent to the central station.
If, for a period defined in GSM ML Time parameter, the GSM signal has always been below the
lower threshold, a Media Loss event is registered in the log and sent to the central station.
The GSM Media Loss event is sent to the central station via PSTN only.
If, for a period defined in GSM ML Time parameter, since GSM media restore is detected, the GSM
signal has always been above the upper threshold, GSM Media Restore is registered in the log and
sent to central station.
To disable the GSM Media Loss feature (cancel the GSM Media Loss events) enter 000.
To program the GSM Media Loss Time:
1.
From the Programming menu, select Communications, Comm. Options, GSM Options,
and GSM ML Time. [954136].
2.
Enter time (003-255 minutes or 000 to disable), then press '
√ʹ
.
10.8. TWA Event Report Options
10.8.1. TWA Event Report
The TWA Event Report is an event report that is sent to the central station to indicate that Two-Way
Audio communication is about to commence. If enabled, the system sends the Contact ID event
code 606000 before establishing Two-Way Audio communication.
This option affects Contact ID only. If using SIA, a TWA event report is always sent together
with the TC/VM timeout, regardless of the configuration for this option.
To program the TWA Event option:
1.
From the Programming menu, select Communications, Comm. Options, and TWA Event
Rept. [95414].
2.
Select Enabled or Disabled.
10.8.2. TWA Time Report
If the TWA Time Report option is enabled, the last three digits of the TWA Event Report are replaced
with the amount of seconds programmed for the TC/VM Timeout – p. 70,
10.6.10 Telecontrol/Vocal
Message Timeout. For example, if the TC/VM Timeout is programmed as 120 seconds, the Contact ID
event code to be sent for the TWA Event Report will be 606120.
To program the TWA Time Report option:
1.
From the Programming menu, select Communications, Comm. Options, and TWA Time
Rept. [95415].
2.
Select Enabled or Disabled.
Summary of Contents for Control system
