2 System Installation
CommPact Installation Manual
11
2.2.5.
Stage 5 – Program Internet Options
The Electronics Line Application Server (ELAS) handles all communication between the system,
service providers and web users, enabling monitoring and control to be performed via the Web.
Internet settings are mostly pre-programmed in the Control System’s default settings. The only
settings you need to program are the Control System’s connection settings and control system
parameters (provided by the ELAS administrator). The following procedures explain how to
program the Control System’s ID (CPID) and Password. For further information regarding other
Internet options and settings, see p. 77,
11 Internet Options.
To program the ELAS IP Address and Port:
1.
Press '
√ʹ.
2.
Enter your Engineer code.
3.
Enter [9571] (Programming, Communications, Internet, and XMP Proxy ID).
4.
Enter the IP address of the ELAS and press '
√ʹ.
5.
Enter the XML port of the ELAS and press '
√ʹ.
For MyELAS, define the IP address as 195.219.118.21 and the Port as 33000.
If the end user is to perform the self registration on-line then the following CPID and CP
Password steps are not required.
To program the CPID:
1.
Press '
√ʹ.
2.
Enter your Engineer code.
3.
Enter [9573]
(Programming, Communications, Internet, and CPID).
4.
Enter an ID using the alphanumeric keypad. The ID length must be six up to sixteen characters.
The ID must begin with a letter.
5.
Press '
√ʹ.
To program the Control System’s password:
1.
Press '
√ʹ.
2.
Enter your Engineer code.
3.
Enter [9574] (Programming, Communications, Internet, and CP Password).
4.
Enter a password using the alphanumeric keypad.
The password length must be six up to sixteen characters. The password must begin
with a letter.
5.
Press '
√ʹ.
2.2.6.
Stage 6 – Permanently Install the Control System and Transmitters
Having chosen and tested the mounting location of the Control System and each transmitter, you
are now ready to permanently install the system.
To permanently install the transmitters, refer to each device’s installation instructions in Appendix
B of this manual or to those supplied individually with each product.
To install the Control System:
1.
Place the drilling template against the wall and mark the mounting holes.
Summary of Contents for Control system
