Comm-Tec UP-82TS, User Manual

Page: 16 / 56

Seamless Switcher
Comm-tec Srl 16 www.comm-tec.it
5. Button Control
5.1 Manual Switching
When the switcher is in manual switching mode, the AUTO button LED goes out. Please
follow the below steps to switch input source to output channel.
1) Press any one of eight input buttons to select input source, and the corresponding
button LED turns blue.
2) Press either 1-HDMI or 2-HDBT output button to select output channel, and the
corresponding button LED turns blue.
3) Press the input button again to confirm switching setting, otherwise, it will automatically
confirm after three seconds.
5.2 Auto Switching
Please follow the below steps to enable auto switching mode for 1-HDMI or 2-HDBT
output.
1) Press AUTO , and the button LED turns blue.
2) Press either 1-HDMI or 2-HDBT output button, and the corresponding button LED turns
blue.
3) Press AUTO button again to confirm the setting, otherwise, it will automatically confirm
after three seconds.
4) Repeat the above three steps can exit auto mode, but the input source will remain the
current setting.
Note: The AUTO button LED illuminates blue when the 1-HDMI output is in auto mode or
the 2-HDBT output in auto mode.
When in auto mode, the switcher will switch according to the following rules:
⚫
The switcher will switch to the first available active input starting at input 1 to 8.
⚫
New input: The switcher will automatically select the new input once detecting a new
input.
⚫
Reboot: If power is restored to the switcher, it will automatically reconnect the input
before powered off.
⚫
Source removed: When an active source is removed, the switcher will switch to the first
available active input starting at 1-HDBT input.
⚫
In auto mode, the input source also can be switched by the manual switching steps.