Colortrac SmartLF Ci 40, Service Manual

Page: 66 / 101

Page 66
Ci Scanner Service Manual
5. Remove the 2 x M3 Pan
Head screws and washers
from the left end plate
that's holding the bearing
in place.
6. Pull the roller back until the
shaft is free of the hole in
the right end plate. Take
the bearing off from the left
end of the roller, and keep
safe. Lift the roller up and
out.
7. Refit the replacement roller
in reverse to taking it out.
Make sure that the longest
roller shaft with the flat
surface goes in the left
side of the scanner with
the drive motor, and goes
in first. Then lower the
other end down and push
through the hole. Refit the
bearings at either end.