Colortrac SmartLF Ci 40, Service Manual

Page: 53 / 101

Page 53
Ci Scanner Service Manual
5. Remove the 4 x M3 Pan
Head Screw holding the
Main Board in place.
6. Lift the board away from
the scanner, and remove
the CIS cables by pulling
them away from the board
as you lift it out.
7. Refit the new board using
the 4xM3 Pan Head
screws. Make sure none
of the cables are trapped
behind the board as it is
put in place.
8. Using tweezers, push the
CIS cables squarely back
into the appropriate
connectors. These cables
are short to comply with
EMC regulations. Take
care not to damage the
cables during insertion.
Make sure the cable fits
completely into the
connector so that little or
no silver is showing.
9. Close the locking plates to
secure the cable and
prevent it being pulled free.