Colortrac SmartLF Ci 40, Service Manual

Page: 47 / 101

Page 47
Ci Scanner Service Manual
5. Before fitting the roller
shaft pulley make sure the
2 x M4 screws are inserted
but are not pretruding into
the hole or cut out for the
shaft key.
NOTE: The M4 x 8 screw goes
into the hole at the shaft key
cut out, and the M4 x 10 in the
hole opposite the cut out.
When the shaft key is fitted,
insert it so the flat side is face
up toward the screw.
6. Insert the shaft key into
place before fitting onto the
shaft. Fit on the shaft so
the shaft key goes over the
flat area of the roller shaft.