Cold Jet 514635, User Manual

Page: 65 / 105

Industrivej 62
DK-6740 Bramming
Denmark
Original
Revision: 2.0
IceTech R1000H
Procedures for Maintenance and Repair
Page:
11-32 of
32
Date: 24.08.18
Init: JM
11. PROCEDURE FOR REPLACING HAMMER ON HOPPER
Before replacing the pneumatic hammer make sure that R1000H is in E-stop state or shut down and that
pneumatic air is disconnected. Remove air hoses. Loosen the screws
[ 2 ] holding the hammer [ 1 ] and
replace the hammer [ 1 ] and reconnect the air supply.
Note!
Components on the hopper are fixed using thread locker. Use heating on the screws/nuts to easier
loosen the components. Make sure to re-apply thread locker when assembling components on the
hopper.
Make sure that the hammer is functioning properly after this operation.
1
2