Colasit CMVpro 125, Operating Instructions Manual, Page: 54 / 76

10 | Maintenance
54 / 76 Operating instructions CMVpro 125-400 | Version 1-en
• For proper mounting and damage: Safeguards (splinter protection, pro-
tective grid with free installation, optional motor cover), and support
• For blockages and missing water: Condensate drain (option) and
siphon
• Replace damaged parts immediately.
2. Test run
• Vibration measurement and condition check of the motor bearings.
Compare measured values with
- limit value according to table
_ Chap. 8.2.3 [ } 48],
- information in the test report from initial commissioning.
• Replace motor bearings at the end of their service life or if they exhibit
significant noise development due to bearing wear. To do this, remove
the electric motor
_
Chap. 11.7 [
}
64].
The motor bearings are lifetime lubricated
_
Chap. 2.2.3 [
}
11]. For information
on the bearing service life, see the operating instructions of the electric motor.
• Check hub seal (option, _ Chap. 4.3.12 [ } 26]) for leakage.
• Measure the current draw of the electric motor. The measured value
may not exceed the rated current on the nameplate.
• Measure temperature of the electric motor and compare with informa-
tion in the technical data sheet.
3. Inside inspection and cleaning
• Check the impeller for deformation and for damage such as cracking
and corrosion.
• If necessary, conduct outside and inside cleaning.
• Check impeller position and adjust if necessary
_
Chap. 11.8 [
}
65].
4. Assembly and final inspection
• Proper mounting of the splinter protection _ Chap. 6.3 [ } 31].
• All screw connections are tight.
• Fixed position of all fastening elements (anchors) in the foundation
(baseplate).
• Short test run, checking for vibration and noise.